[. . . ] Please keep this guide along with the code list (provided separately), so that you can subsequently programme your remote control for use with other sets. RECORD: keys printed in grey in these Instructions have the same functions as those of your VCR, your original remote control or your DVD DTH 1000/2000/2500 THOMSON. ZOOM-, ZOOM+: for horizontal travelling through the menus (with sets supporting this feature). [. . . ] Hold down the key SET UP (17) until the red indicator lamp (13) remains lit. The indicator lamp remains on for a couple of seconds, so that you have time enough to proceed with step 4. The indicator lamp flashes to signal that this time is almost up, and then goes off. While the indicator is lit, enter the first digit of the 3-digit code proposed for the set to be controlled (example: 016 for THOMSON). The red indicator then goes off or flashes, if the code is not on the list. Direct the remote control towards the set and try to switch it off by pressing the key B (1). Check of the programming In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the key SET UP (17) until the red indicator lamp (13) remains lit. Direct the remote control towards the set and try to switch it off by pressing the key B (1). Should the set not switch off, press key B (1) as many times as required (up to 200 times), until the set switches off. Between two subsequent key depressions, give the red indicator lamp (13) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. [. . . ] The THOMSON NAVILIGHT system allows you easy access to the settings of your television (TV) or video recorder (VCR) including this feature. In the VCR position, make sure that the AV mode is activated for the TV set (the SCART socket must be selected). Navigate through the setting menus with the keys up, down, left, right (7 and 8). [. . . ]